Hardware Troubleshooter - Dell Latitude E4300 Service Manual

Troubleshooting: Dell Latitude E4300 Service Manual
WARNING: The second battery cannot be identified. this system will be unable to charge batteries until this
battery is removed. —
battery or system board may be defective.
WARNING: The batteries cannot be identified. this system will be unable to charge batteries until this battery is
removed. —
For computers with two batteries installed, one or more of the batteries may be installed incorrectly, or the
batteries or system board may be defective.
WARNING: The battery cannot be identified. this system will be unable to charge this battery. —
be installed incorrectly, or the battery or system board may be defective.
WARNING: The battery attached cannot power the system. The system will not boot with this battery plugged in.
Press F1 to shutdown the system.
WARNING! Battery is critically low. hit F1 to continue.
WARNING: The TPM could not be initialized —
Contacting Dell).
Warning messages have been disabled. run the setup utility to enable these messages. —
the system setup program, see the Dell Technology Guide on your computer or at support.dell.com.
WARNING: Dell's disk monitoring system has detected that drive [0/1] on the [primary/secondary] eide
controller is operating outside of normal specifications. it is advisable to immediately back up your data and
replace your hard drive by calling your support desk or
dell. —
Contact Dell for assistance (see
Your power adapter does not supply enough power to run the attached docking station. either undock or insert
an appropriate adapter. strike the F1 key to shutdown. —
Your system is docked, but the AC adapter type cannot be determined. either undock or insert an appropriate
adapter. strike the F1 key to shutdown. —
station may be defective.
Your system automatically power off because it became warmer than expected. this may have been caused by:
operating or storing the system in an environment where the ambient temperature is too high, or obstructing the
air flow from the system fan vents. if the problem recurs, please call dell support with error code #M1004. —
Contact Dell for assistance (see
***Processor SSDT data not found*** operating system power management for mult core processors will be
disabled. —
***UL circuit tripped*** the UL trip count is shown below the F3-key message. strike the F3 key to clear the UL
counter, any other key to continue. —
***Processor microcode update failure*** the revision of processor in the system is not supported. —
Ensure that the processor you are using is supported by your computer. See "Specifications" in the Setup and Quick
Reference Guide.

Hardware Troubleshooter

If a device is either not detected during the operating system setup or is detected, but incorrectly configured, you can use the
Hardware Troubleshooter to resolve the incompatibility.
® ®
Windows Vista :
1. Click the Windows Vista start button
file:///C|/Biz%20Client/2015/Lola%20(Defect%20Fix)/trouble.htm[5/25/2015 11:14:02 AM]
For computers with two batteries installed, the secondary battery may be installed incorrectly, or the
Contacting
The AC adapter may be installed incorrectly, or the AC adapter or docking
Contacting Dell).
Run the Dell Diagnostics (see
, and click Help and Support.
System board failure may have occurred. Contact Dell for assistance (see
Dell).
Connect the correct AC adapter.
Dell
For information on using
Diagnostics).
The battery may