Serial Plate Information - Kenmore 79097212410 Installation Instructions Manual

B. Drill Pilot Holes and Fasten Bracket
- Drill
a 1/8" pilot hole where screws are to be located. If
bracket is to be mounted to the wall, drill pilot hole at
an approximate 20 ° downward angle. If bracket is to be
mounted to masonry or ceramic floors, drill a 3/16" pilot
hole 1-3/4" deep. The screws provided may be used in
wood or concrete material. Use a 5/16" nut-driver or flat
head screwdriver to secure the bracket in place.
FASTEN BRACKET
(WALL OR FLOOR MOUNTING)
"--_1 1---1-114" Max.
Leveling leg
mount
p Bracket
FASTEN BRACKET
(FLOOR MOUNTING ONLY)
"--_1 ,_More than
Figure 2
C. Level and position the range-
Slide range
to its final position. Insert the range leveling leg in the
anti-tip bracket. Visually verify if the anti-tip bracket is
engaged. Lower the range by adjusting the 4 leveling
legs alternatively until the range is level. Check if the
range is level by placing a spirit level on the oven rack.
Take 2 readings with the spirit level placed diagonally;
take a reading in one direction and then in the other
direction. Level the range if necessary by adjusting the
leveling legs.
Figure 4
Figure 5
4. Serial Plate Information
The serial plate is located as shown. See the serial
plate for the following information:
A. Model, lot and serial number of range.
B. Kilowatt rating (power requirements).
C. Voltage ratings.
Rang
Figure 6
Figure 3
4