Table of Contents
Advertisement
Mounting the Camera in the Housing
CAUTION
Make sure to release the camera's focus selector lock.
Remove the strap or the LCD monitor cover from the camera, if any of these
accessories are attached.
1
Rotate the quick lock in the
OPEN direction (
), and then
remove the quick shoe from the
front case (
)
2
Switch the camera's focus-mode
selector to M
3
With the A groove on the quick
shoe aligned with the focus-mode
selector, fix the quick shoe on the
camera's tripod socket
4
Attach the lens to the camera
5
Make sure the quick lock is in the OPEN position
E-13
6
Align the quick shoe with
the quick shoe base, and
slide the camera fully
forward into the front case
7
Align the quick lock with the LOCK position to fix the camera
in place
8
Rotate the power switch on the housing so that it is facing the
same way as the power switch on the camera
9
Attach the L-hook to the front
case
AF M
A
10
Fixing screw
Mounting the camera in the Housing
To make sure that the gear attached
to the lens and the gear on the
front case do not hit each other,
rotate the focus / zoom dial while
sliding the camera into place.
Close the locking latches
See:
"Opening and Closing the Housing" (P.E-9)
Make sure that the O-ring is properly fitted in the O-ring groove before
setting of the rear case.
L-hook
E-14
Advertisement
Table of Contents
