Connecting The Strobe - Sea&Sea MDX-D800 Instruction Manual

Mounting the Camera in the Housing
Removing the camera from the housing
1
Open the locking latches
2
Remove the rear case
3
Set the quick lock to the OPEN position
4
Slide the camera toward you as you remove the front case
CAUTION
If you find the fix screws are too tight, use a coin or similar object to loosen
the screws.
E-15

Connecting the Strobe

Connect the strobe with the fiber-optic cable (option) when the strobe is
triggered by sensing the light from the camera's built-in flash.
1
Remove the fiber-optic cable
socket caps
2
Insert the fiber-optic cable's
connector into the socket until
it stops
Do not remove the caps from fiber-
optic cable socket not in use to keep
light from entering in.
CAUTION
Before inserting the fiber-optic cable, check to make sure that there are no
scratches or dirt on the connector surface. Scratches or dirt may cause the
strobe to malfunction.
To protect the surface from scratches or dirt, do not remove the caps from
the fiber-optic cable sockets when the cable is not inserted.
There is no possibility of water leaking from the fiber-optic cable socket
even if the fiber-optic cable/cable socket cap is removed underwater.
After the strobe is connected to the housing, make sure to check that the
connected strobe functions correctly before underwater use.
Fiber-optic cable socket cap
E-16