Sea&Sea MDX-D800 Instruction Manual page 12

Attaching the Optional Accessories
Finder
This product comes equipped with a 0.5x pick-up finder. The finder can
be replaced with an optional finder so you can change the finder magnifi-
cation to match your shooting conditions.
Replacing the finder Unit
The optional VF45 1.2x (46111) or
VF180 1.2x(46112) enhances
magnification by 1.2x and enables
subtle framing and focusing of
subjects.
CAUTION
When replacing the finder unit, always refer to the instruction manual
provided with the VF45 1.2x or VF180 1.2x.
Replacing the pick-up finder
1
Rotate the finder unit mounted on
the rear case in a counterclockwise
direction to remove it
The screw areas are coated in
grease, so be careful not to touch
them.
2
Rotate the replacement finder
unit in a clockwise direction to
attach it
CAUTION
Before attaching the finder, check to make sure that there is no dust, dirt,
or debris inside it.
When replacing the finder, do not touch the surface of the finder lens.
When replacing the pick-up finder, always refer to the instruction manual
provided.
E-21
Arm
For Sea Arm VII system
The Sea Arm VII system can be
attached by mounting the optional
Bracket Shoe (20100) on the hand
grips.
For Sea Arm 8 system
The Sea Arm 8 system can be
attached by mounting the optional
Bracket Shoe (20100) or SA8 Fixed
Ball Base (22119) on the hand grips.
CAUTION
Use the smaller hex wrench (3mm) provided when removing the lanyard
bolts.
Attaching the Optional Accessories
smaller Hex wrench
Lanyard bolt
Tighten
Lanyard
hook
Bracket shoe
E-22