Table of Contents
Advertisement
External Controls
Main command dial
Rotate the dials while pressing them in
to operate them.
Other controls
Other control parts on the housing correspond to the operation parts of the
digital camera. Refer to the camera's instruction manual for details of each
function.
CAUTION
After mounting the camera in the housing, make sure to check that all of the
housing's control parts work properly and the camera functions correctly
before underwater use.
E-19
This product accepts SEA&SEA optional accessories. By using this
product in combination with those accessories, you will be able to try
various shooting techniques.
Connecter
With the Optional YS Converter/N 5-pin Connector
(50123) or Optional Sync Cord 2-pin Connector
(50122) installed in the connector hole, you can
connect SEA&SEA strobe sync cords.
Main command dial
Leak Sensor
The leak sensor is optionally available and can
be attached to the leak sensor mount.
The leak sensor lights up in red if water leakage
is detected while underwater. If the leak sensor
lights up, surface as soon as you safely can
and remove the camera from the housing.
Attaching the Optional Accessories
CAUTION
Lenses, strobes and other accessories have different depth rating. Check the depth rating
for each before use.
Read the instruction manual for each accessory before use.
CAUTION
When attaching the Strobe bulkhead, always
refer to the instruction manual provided.
CAUTION
If a lot of water leaks in, the atmospheric
pressure inside the housing will increase,
which is very dangerous. When releasing the
locking latches, the rear case could come
flying off, so be very careful.
YS Converter/N 5-pin Connector
or
Sync Cord 2-pin Connector
Leak Sensor
E-20
Advertisement
Table of Contents
