Zanussi ZCI660MXC User Manual page 10

Timer
Count Down Timer
You can use this function to set how long the
cooking zone should operate for a single
cooking session.
First set the cooking zone then set the
function. You can set the heat setting before
or after you set the function.
To set the cooking zone: touch
again until the indicator of a necessary cooking
zone comes on.
To activate the function: touch
timer to set the time (00 - 99 minutes). When
the indicator of the cooking zone starts to flash
slowly the time counts down.
To see the remaining time: set the cooking
zone with . The indicator of the cooking zone
starts to flash quickly. The display shows the
remaining time.
To change the time: set the cooking zone
with . Touch or
To deactivate the function: set the cooking
zone with and touch
counts back to 00. The indicator of the cooking
zone goes out. To deactivate the function you
can also touch and
When the time comes to an end, the
sound operates and 00 flashes. The
cooking zone deactivates.
To stop the sound: touch
CountUp Timer (The count up timer)
You can use this function to monitor how long
the cooking zone operates.
To set the cooking zone: touch
again until the indicator of a necessary cooking
zone comes on.
To activate the function: touch
timer. comes on. When the indicator of the
cooking zone starts to flash slowly the time
counts up. The display switches between
and counted time (minutes).
To see how long the cooking zone
operates: set the cooking zone with
indicator of the cooking zone starts to flash
10
again and
of the
.
. The remaining time
at the same time.
.
again and
of the
. The
quickly. The display shows how long the zone
operates.
To deactivate the function: set the cooking
zone with and touch
of the cooking zone goes out.
Minute Minder
You can use this function as a Minute Minder
when the hob is activated and the cooking
zones do not operate (the heat setting display
shows ).
To activate the function: touch
or of the timer to set the time. Cooking
zones display deactivates automatically after 10
seconds. When the time comes to an end, the
sound operates and 00 flashes.
To stop the sound: touch
To deactivate the function: activate for a
short time and deactivate left front cooking
zone.
The function has no effect on the
operation of the cooking zones.
STOP+GO
This function sets all cooking zones that operate
to the lowest heat setting.
The function does not stop the timer functions.
To activate the function: touch
comes on.
To deactivate the function: touch
previous heat setting comes on.
If you change the heat setting, the
function stops and the display
shows the new heat setting.
Lock
You can lock the sensors on the hob while
cooking zones operate.
Set the heat setting first.
To activate the function: touch
comes on for 4 seconds. The Timer stays on.
To deactivate the function: touch
previous heat setting comes on.
or . The indicator
. Touch
.
.
. The
.
. The
www.zanussi.com