Closing The Casing; Adding Memory; Removing Memory Modules - Fujitsu FUTRO S900 Operating Manual

System expansions

Closing the casing

Casing cover Casing
► Replace the casing cover on the device and push it backwards.
► Secure the casing cover with the two screws on the rear of the device.
Make sure that the cables are not trapped between the casing and the components.
► Connect all the cables removed before.

Adding memory

Memorymodule
System expansion System expansion Removing memory Mainmemory
If you want to remove or add memory, proceed as follows:
Please observe the safety information in chapter
Only use memory extensions for notebooks: 1 GByte and 2 GByte modules
DDDR3-1333 SO DIMM or DR3-1066 SO DIMM.
Never use force when installing or removing a memory extension.
Make sure that foreign objects do not fall into the memory extension compartment.
Individual components (e.g. the processor heat sink) can become very hot
during operation. We therefore recommend that you wait one hour after
switching off the device before removing or installing the memory modules.
Otherwise, there is a risk of suffering burns!
As some components are exposed that are sensitive to static electricity, please
take note of chapter

Removing memory modules

3
1
Fujitsu Technology Solutions
"Information about boards", Page 19 -
2
1
"Important notes", Page 4 -
► Carefully push the two mounting
clips outwards (1).
Memory module Memory expansion

The memory module snaps upwards (2).
► Pull the memory module out of its slot
in the direction of the arrow (3).
English - 21
English.
English.
63