Removing The Smartcard Reader - Fujitsu FUTRO S900 Operating Manual

System expansions

Removing the SmartCard reader

SmartCardreader
► Open the casing (see
► If a PCI or PCIe board is installed, remove the cross piece and PCI or PCIe
board (see "Removing the board", Page 38 -
► Disconnect the cable from the SmartCard reader (1) and from the mainboard (2).
► Undo the screws (3).
► Lift the SmartCard reader from the carrier (4).
► Reinstall the cross piece and the PCI or PCIe board if necessary (see
"Installing the board", Page 36 -
► Close the casing (see
Ensure that cables are not trapped between the casing and the components.
Fujitsu Technology Solutions
"Opening the casing", Page 20 -
English).
"Closing the casing", Page 21 -
English).
English).
2
1
English).
English - 25
3
3
4
67