Route Wires And Attach Connectors - Bosch VG4 Series Installation Manual

AutoDome Modular Camera System
1.4

Route Wires and Attach Connectors

Power wires must be routed to the left (front) side of the Power Supply Box through a sepa-
rate conduit. All video, control, and alarm wires must be routed through a second conduit to
the right side of the box.
WARNING! External interconnecting cables are to be installed in accordance to NEC,
ANSI/NFPA70 (for US application) and Canadian Electrical Code, Part I, CSA C22.1 (for CAN
application) and in accordance to local country codes for all other countries.
!
Branch circuit protection incorporating a 20 A, 2-pole Listed Circuit Breaker or Branch Rated
Fuses are required as part of the building installation. A readily accessible 2-pole disconnect
device with a contact separation of at least 3 mm must be incorporated.
Fig. 1.3 Pendant Arm Power Supply Box
1. Route all video, control, and alarm wires through the conduit fitting on the right side of
the power box. See Chapter 4: Cable and Wire Standards for coax, UTP, and fiber optic
specifications and distances.
2. Route the high voltage 115/230 VAC lines through the conduit fitting on the left side of
the box. The Power Supply Box with a transformer comes with a barrier that separates
the high voltage side on the left, from the low voltage 24 VAC side on the right.
3. Cut and trim all wires with sufficient slack to reach their connector terminals in the box,
but not so long as to be pinched by or to obstruct closing the Pendant Arm. See
Figure 1.5 on page 9 for the connector locations.
4. Attach the supplied 3-pin Power Plug to the incoming power wires. See connector P101
in Table 1.1 on page 9 for wire connections.
Bosch Security Systems, Inc.
Installing the Pendant Arm Wall, Corner, and Mast (Pole) Mounts | en 7
J102
24 VAC
P101
LINE NC NEUT
P106 P105
GND TXD RXD C+ C- GND TXD RXD C+ C-
Installation Manual
(LED)
F01U010921 | 1.0 | 2006.10