Troubleshooting - Jura GIGA X3 Operating & Cleaning Instructions

Troubleshooting:

Milk flow
No milk Spluttering milk
Solution:
1. Remove the splash back screen.
2. Press the black releasing buttons on the sides of the spout cover and lift the cover off.
3. If the flat milk is flowing normally and the problem is with the froth milk only, replace the air suction
refit the cover and test the milk again. If the problem has been solved, purchase spare air suction (Part no.
70008). If the problem has not been solved go to step 4.
4. Remove the auto frother by pulling the milk outlet down
6). Now you will be able to remove the auto frother by pulling it towards you
5. Separate the auto frother into 6 parts
6. Remove the parts from the solution and rinse under tap water.
7. Clean the milk, air and steam paths using the cleaning brushes. See 2 x milk path holes in Fig
8. Pour tap water into the top of the milk outlet
replace it with your spare outlet and order in another spare. (Part no. 70007)
9. Re-assemble the auto frother ensuring that the arrow tips line up.
10. Refit the auto frother, cover, splash back and test milk. If the problem has not been solved ph 1300 365 487.
Figure 1
Figure 6
Figure 11 (Milk path)
Not filling cups
(Fig 1)
(Fig 8),
Figure 2 Figure 3
Figure 7 Figure 8
Figure 13 (Steam path)
Figure 12 (Air path)
Froth milk is flat
(Fig 5) and pulling the milk hose connector out
soak in 250ml of warm water & 15ml of milk cleaner for 20 min.
(Fig 14). If water does not pour from the two outlets as shown,
(Fig 15)
Figure 4
Figure 9 (Milk path)
Figure 14 (Test outlet)
(Fig 2 – 3)
(Fig
(Fig 7).
11.(Fig 9 – 13)
Figure 5
Figure 10 (Milk path)
Figure 15
4),
(Fig