Table of Contents
Advertisement
LLDP C
OMMANDS
-
-
LLDP MED
TLV
SELECT
lldp med-tlv-select
Overview
Use this command to enable LLDP-MED Organizationally Specific TLVs for
transmission in LLDP advertisements via the specified ports. The LLDP-MED
Capabilities TLV must be enabled before any of the other LLDP-MED
Organizationally Specific TLVs are enabled.
Use the no variant of this command to disable the specified LLDP-MED
Organizationally Specific TLVs for transmission in LLDP advertisements via these
ports. In order to disable the LLDP-MED Capabilities TLV, you must also disable the
rest of these TLVs. Disabling all these TLVs disables LLDP-MED advertisements.
Syntax
lldp med-tlv-select {[capabilities] [network-policy] [location]
[inventory-management]}
lldp med-tlv-select all
no lldp med-tlv-select {[capabilities] [network-policy]
[location] [inventory-management]}
no lldp med-tlv-select all
Default
By default LLDP-MED Capabilities, Network Policy, Location Identification and
Extended Power-via-MDI TLVs are enabled. Therefore, if LLDP is enabled using the
1380
Parameter
capabilities
network-policy
location
inventory-management Inventory Management TLV Set, including the following
all
Command Reference for x230 Series Edge Switches
AlliedWare Plus™ Operating System - Version 5.4.5-0.x
Description
LLDP-MED Capabilities TLV. When this is enabled, the
MAC/PHY Configuration/Status TLV from IEEE 802.3
Organizationally Specific TLVs is also automatically
included in LLDP-MED advertisements, whether or not it
has been explicitly enabled by the
command.
Network Policy TLV. This TLV is transmitted if Voice VLAN
parameters have been configured using the commands:
Location Identification TLV. This TLV is transmitted if
location information has been configured using the
commands:
TLVs:
• Hardware Revision
• Firmware Revision
• Software Revision
• Serial Number
• Manufacturer Name
• Model Name
• Asset ID
All LLDP-MED Organizationally Specific TLVs.
lldp tlv-select
C613-50055-01 REV A
Advertisement
Table of Contents
