Lldp Med-Tlv-Select - Allied Telesis IE340 Series Command Reference Manual

LLDP C
OMMANDS
- -
LLDP MED TLV SELECT

lldp med-tlv-select

Overview Use this command to enable LLDP-MED Organizationally Specific TLVs for
transmission in LLDP advertisements via the specified ports. The LLDP-MED
Capabilities TLV must be enabled before any of the other LLDP-MED
Organizationally Specific TLVs are enabled.
Use the no variant of this command to disable the specified LLDP-MED
Organizationally Specific TLVs for transmission in LLDP advertisements via these
ports. In order to disable the LLDP-MED Capabilities TLV, you must also disable the
rest of these TLVs. Disabling all these TLVs disables LLDP-MED advertisements.
lldp med-tlv-select [capabilities] [network-policy] [location]
Syntax
[power-management-ext] [inventory-management]
lldp med-tlv-select all
no lldp med-tlv-select [capabilities] [network-policy]
[location] [power-management-ext] [inventory-management]
no lldp med-tlv-select all
C613-50631-01 Rev A
Parameter
capabilities
network-policy
location
power-management-ext Extended Power-via-MDI TLV. This TLV is transmitted if
Command Reference for IE340 Series
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
Description
LLDP-MED Capabilities TLV. When this is enabled, the
MAC/PHY Configuration/Status TLV from IEEE 802.3
Organizationally Specific TLVs is also automatically
included in LLDP-MED advertisements, whether or not it
has been explicitly enabled by the
command.
Network Policy TLV. This TLV is transmitted if Voice VLAN
parameters have been configured using the commands:
• switchport voice dscp
• switchport voice vlan
• switchport voice vlan priority
Location Identification TLV. This TLV is transmitted if
location information has been configured using the
commands:
• location elin-location-id
• location civic-location identifier
• location civic-location configuration
• location coord-location identifier
• location coord-location configuration
• location elin-location
the port is PoE capable, and PoE is enabled
enable command).
lldp tlv-select
(power-inline
3223