Nozzle (3) and Needle (12) – Remove
parts in the following order: 14, 13, 12,
1, 2 and 3. Examine the seal (4) and
replace if damaged. Replace any other
worn or damaged parts and re-assemble
tightening torque for nozzle (3) 20-27
Nm (15-20 lbf ft)
Packing – Remove parts
Unscrew cartridge (26). Fit new cartridge
finger tight. Re-assemble parts 12, 13,
and 14 and tighten Packing Nut (25) with
Spanner – order SPN-5
Cleaning Brush – order 4900-5-1-K3
Pressure gauge Attachment – order GA-515
Gun Mounted Regulator – order DVR-501
Lubricant - order GL-1-K10
Replacement of Parts
14, 13, 12.
heavy duty towels, capable
of removing paint, grease,
grime and dirt from hands
and tools whout the use of
water. Available in buckets
of 72 wipes.
spanner sufficient to seal but to allow
free movement of needle. Lubricate with
Air valve – Remove parts 17, 16 and
assemble parts in reverse order.
Spreader valve – Caution: always
ensure that the valve is in the fully open
position by turning screw fully counter-
clockwise before fitting to body.
© 2003 ITW Finishing Systems and Products