Table of Contents
Advertisement
10. ALIGNMENT
If the maximum value of "noise" read by the sensor is very close to the peak value, it might be diffi cult to place the
value of the "Notch Threshold" at an intermediate point. In these cases, it is mandatory that the portion of paper be-
tween the point of printing end and the front notch is completely white (no graphics). In this way, the only next graphic
detected by the sensor for alignment after the printing end will be the notch.
10.3 Alignment parameters
The "alignment point" is defi ned as the position inside the ticket to use for the notch alignment.
The distance between the notch edge and the alignment point is defi ned as "Notch Distance".
If the "Notch Distance" value is set to 0, the alignment point is set at the beginning of the notch.
alignment point = notch front
alignment point
PRINTING DIRECTION
0
positive values of "Notch Distance"
The "Notch Distance" value can have a minimum value of 0mm and a maximum of 99,9mm. This maximum value is
imposed by the mechanical distance between the notch sensor and the printing head.
KPM216HII 83
User manual
Advertisement
Table of Contents
