Table of Contents
Advertisement
10. ALIGNMENT
The following fi gure shows a section of the device with the paper path and the distances (in mm) between the align-
ment sensors, the printing head and the cutter (cutting line).
ESC/POS
TM
EMULATION
To defi ne the alignment point you need to set the printer parameters that compose the numerical value of the "Notch
Distance" parameter (see par.5.4).
For example, to set a notch distance of 10 mm between the notch and the alignment point, the parameters must be
set on the following values:
Notch Distance [mm x 100]
Notch Distance [mm x 10]
Notch Distance [mm x 1]
The "Notch Distance" parameter, may be modifi ed as follows:
•
during the Setup procedure of the device (see chapter 5)
•
by using the $1D $E7 command (for more details, refer to the Commands Manual)
•
by driver (facility tool).
84 KPM216HII
User manual
: 0
: 1
: 0
30
25.5
Advertisement
Table of Contents
