OEM KPM216HII User Manual page 42

5. CONFIGURATION
AUTOFEED
PRINT MODE
CHARS / INCH
SPEED / QUALITY
AUTOMATIC EJECTING
PAPER RETRACTING
DOT DAMAGE
PREVENTION
NOTCH ALIGNMENT
42 KPM216HII
User manual
Setting of the Carriage Return character:
CR disabled D = Carriage Return disabled
CR enabled = Carriage Return enabled
Printing mode:
D
Normal = enables printing in normal writing way
Reverse = enables printing rotated 180 degrees
Font selection:
200dpi models
A = 11 cpi, B = 15 cpi D
A = 15 cpi, B = 20 cpi
NOTE: CPI = Characters Per Inch
Setting of printing speed and printing quality:
D
Normal
High Quality
High Speed
Setting of the automatic ejecting function of the last printed ticket in presentation mode:
Disabled D = ejecting function disabled
Enabled T.out 5s = the ticket is ejected after 5 seconds from the end of printing
Enabled T.out 10s = the ticket is ejected after 10 seconds from the end of printing
Enabled T.out 15s = the ticket is ejected after 15 seconds from the end of printing
Enabled T.out 20s = the ticket is ejected after 20 seconds from the end of printing
Enabled T.out 30s = the ticket is ejected after 30 seconds from the end of printing
Enabled T.out 40s = the ticket is ejected after 40 seconds from the end of printing
Enabled T.out 60s = the ticket is ejected after 60 seconds from the end of printing
Enabled T.out 2m = the ticket is ejected after 2 minutesfrom the end of printing
Setting of the automatic retracting function of the last printed ticket in presentation
mode:
D
Disabled = "retract" function disabled
Enabled No Timeout = "retract" function enabled and executable with the command
Enabled T.out 5s = the ticket is retracted after 5 seconds from the end of printing
Enabled T.out 10s = the ticket is retracted after 10 seconds from the end of printing
Enabled T.out 15s = the ticket is retracted after 15 seconds from the end of printing
Enabled T.out 20s = the ticket is retracted after 20 seconds from the end of printing
Enabled T.out 30s = the ticket is retracted after 30 seconds from the end of printing
Enabled T.out 40s = the ticket is retracted after 40 seconds from the end of printing
Enabled T.out 60s = the ticket is retracted after 60 seconds from the end of printing
Enabled T.out 2m = the ticket is retracted after 2 minutes from the end of printing
Setting of the function of preventing the deterioration of the dot solicited frequently
by special prints (eg, graphs or tables):
D
Disabled = Prevention disabled
±0.6mm(±7dots)
±1.3mm(±15dots)
Management of the alignment notch
Disabled D = the notch alignment is not performed
Enabled = the notch alignment is performed
300dpi models
A = 16 cpi, B = 23 cpi D
A = 23 cpi, B = 30 cpi