Setting [E-TTL II meter.] to [Evaluative] is recommended.
Even though the firing of the built-in flash is disabled when
[EasyWireless] is set, it will still fire a small flash in order to control the
slave unit. Depending on shooting conditions, the flash fired to control
the slave unit may appear in the picture.
Firing a test flash is not possible with the slave unit.
Select [Built-in flash settings].
4
Select [Built-in flash settings], then
press <0>.
Select [EasyWireless].
5
For [Built-in flash], select
[EasyWireless], then press <0>.
Set [Channel].
6
Set the transmission channel (1-4) to
the same one as the slave unit.
Take the picture.
7
Set the camera and take the picture
in the same way as with normal
shooting.
Exit the wireless flash shooting.
8
For [Built-in flash], select
[NormalFiring].
Easy Wireless Flash ShootingK
183