Changing The Metering Mode (Metering Mode) - Canon EOS REBEL T6i Instruction Manual

q Changing the Metering ModeK
Four methods (metering modes) to measure the subject's brightness
are provided. Normally, evaluative metering is recommended.
In Basic Zone modes, metering mode is set automatically.
Select [Metering mode].
1
Under the [z2] tab, select [Metering

mode], then press <0>.
Set the metering mode.
2
Select the desired metering mode,

then press <0>.
Evaluative metering
q
General-purpose metering mode suited even
for backlit subjects. The camera sets the
exposure automatically to suit the scene.
Partial metering
w
Effective where there are much brighter lights
around the subject due to backlight, etc. The
gray area in the left figure is where the
brightness is metered to obtain the standard
exposure.
Spot metering
r
Effective when metering a specific part of the
subject or scene. The gray area in the left figure
is where the brightness is metered to obtain the
standard exposure. This metering mode is for
advanced users.
157