Canceling Aeb - Canon EOS REBEL T6i Instruction Manual

Canceling AEB

Follow steps 1 and 2 to turn off the AEB range display (set to 0).

The AEB setting will also be canceled automatically if the power

switch is set to <2>, flash recycling is completed, etc.
Shooting Tips
Using AEB with continuous shooting

If the drive mode is set to <i> or <M> (p.112) and you press the
shutter button completely, the three bracketed shots will be taken
continuously in this sequence: standard exposure, decreased
exposure, and increased exposure. The shooting will then stop
automatically.
Using AEB with single shooting (u/B)

Press the shutter button three times to take the three bracketed
shots. The three bracketed shots will be taken in the following
sequence: standard exposure, decreased exposure, and increased
exposure.
Using AEB with the self-timer or a remote controller (sold

separately)
With the self-timer or a remote control shooting (<Q> or <l>),
you can take three continuous shots after a 10-sec. or 2-sec. delay.
With <q> (p.114) set, the number of continuous shots will be three
times the number set.
During AEB, <A> in the viewfinder and AEB range will blink.

AEB cannot be used with flash, [Multi Shot Noise Reduction], Creative

filters, or bulb exposures.
If [z2: Auto Lighting Optimizer] (p.136) is set to any setting other

than [Disable], the effect of AEB may be reduced.
3 Auto Exposure BracketingK
161