Setting up
Using the Mouse Emulator Function
The mouse emulator function lets you make settings and adjustments by using a mouse
cursor.
To use the mouse cursor, first set up the mouse emulation mode by following the below
procedure.
In the emulation mode, the numeric keys and Trigger R key are used to manipulate
the mouse cursor. (In the emulation mode, the numeric keys and Trigger R key
cannot be used for entering numerics and scanning bar codes respectively.)
■ Activating the mouse emulator function
•
While no mouse cursor is shown on the screen, press the "Fn" key followed by the
"4" key. The mouse cursor appears, and the mouse emulator function is now active.
*
To turn off the function, press the same key sequence again, i.e. "Fn" key ➝ "4" key.
*
Each push of this key toggles the function between on and off.
■ Using the mouse cursor
Activate the mouse emulator function as described above.
Mouse cursor movement
•
Press a numeric key for the direction in which you want to move the mouse cursor.
* Holding down a key moves
the mouse cursor continuously.
Left click
This serves for selecting a file, making a menu selection, or a similar action.
•
Move the mouse cursor to the position where you want to click, and press the "5"
key.
Mouse cursor moves
in the arrow direction.
E-7