Casio DT-X100 Series User Manual page 39

Status of Indicator  on DT-X00:
Orange: Charging the battery pack.
Red: Standby due to battery pack error or the surrounding temperature is out of the
charging temperature range.
(charging begins when the temperature is within the charging temperature range)
Green: Charging the battery pack is complete.
Important!
Always make sure to first remove the Handheld Terminal from the USB Cradle
•
when switching the selector switch.
Allowing the power contacts become wet can cause an electric shock or fire. In
•
addition, if the contacts become soiled, contact may be impaired resulting in
poor charging. For reasons of safety and maintaining charging battery pack(s)
in optimum condition, clean the power contacts by wiping with a dry cloth or
cotton swab after disconnecting the AC adaptor.
Never short out the power contacts of the USB Cradle. This can damage the
•
USB Cradle.
Note that subjecting the Cradle to impacts or strong vibration could dislodge the
•
Handheld Terminal. Also avoid any vibration or impacts during communication
with a USB client or USB host as this can cause communication to be interrupted.
When placing the DT-X100, make sure that it is seated properly and that
•
the power LED at the front of the USB Cradle is lit in green. Charging and
communication will not proceed properly if the Handheld Terminal is not seated
properly.
Always cap ports that are not being used. Using the USB Cradle while the ports
•
are uncapped can cause damage.
Where there are no mounting slots in the battery pack cover on the back of the
•
DT-X100, the HAF60IOA cannot be used.
(HA-F60IOA only)
•
Do not attempt to pick up the DT-X100 while it is still in the USB Cradle. Doing
so could result in the USB Cradle falling unexpectedly and causing injury or
damage.
If the USB Cradle will not be used for an extended period, set the Power Switch
•
to off.
Place the Cradle on a flat, level surface and take care when placing the DT-X100
•
in or removing it from the cradle.
E-37