Connecting A Video Player - InFocus LitePro 610 Quick Start Manual

Connecting a Video Player

1 If your video player uses a round, one-prong composite video
connector, you'll need only the A/V cable that shipped with
the projector.
If your video player uses a round, four-prong S-video con-
•
nector, you'll also need an S-video cable in addition to the
A/V cable. The S-video cable is sold separately. (See
"Accessories" on page 53.)
2 Plug the A/V cable's yellow connector into the "video-out"
port on your video player (Figure 16). This port may be
labeled "To Monitor."
If you're using an S-video cable, connect it to the "s-video
•
out" connector on the video player (Figure 17).
3 Plug the other yellow connector into the
video) connector on the back of the projector.
If you're using S-video, plug the other end of the cable into
•
the (s-video) connector on the projector (Figure 17).
Connecting the projector to a video player using the standard A/V cable (with composite
Downloaded from ProjectorsManual.com Manuals
(composite
audio/video cable
F 16
IGURE
video connector)
17