InFocus LitePro 610 Quick Start Manual page 48

M a i n t e
CAUTION: Never operate the
projector with the lamp cover open
or removed. This disrupts the air
flow and causes the projector to
CAUTION: Be sure to replace
the projection bulb as soon as
possible after the lamp monitor
light comes on. If the lamp
remains in use too long, there is a
danger of lamp explosion. If this
happens, your LitePro will be
severely damaged.
42
Downloaded from ProjectorsManual.com Manuals
n a n c e
Using a small, flat-blade screw driver, remove the two
•
screws on the bottom of the projector on the outside of the
lamp module cover.
Pull the lamp cover up and remove it.
•
overheat.
F
IGURE
Removing the lamp module cover
4 Remove the lamp module.
Lift the ring of the screw fastener up and turn it 1/4 turn
•
counterclockwise (the screw remains attached to the lamp
module).
F
IGURE
Turning the ring of the screw fastener
& T r o u b
35
36
l e s h o o t i n g