Table of Contents
Advertisement
2. Place the OS/2 Display Driver Diskette in drive A. Type
A:<ENTER> to make this the default drive. Then type INST2X
A: C: <ENTER> (for OS/2 2.1x systems) or INST30 A: C:
<ENTER> (for OS/2 Version 3 systems). Once the Install Program is
completed, do a system shutdown and reboot.
3. After the system has rebooted, follow these instructions:
A) OS/2 2.1x
Open an OS/2 full-screen or windowed session. At the OS/2
prompt, type DSPINSTL <ENTER> to install the new device
driver and configure the video system.
B) OS/2 Version 3
Go to the System Setup folder and run Selective Install to install the
new device driver and configure the video system.
Follow the instructions of the program to set up the OS/2 drivers in
your system. First, select Primary Display. From the list of Primary
Display Adapter Types, select Chips and Technologies 655XX.
From the list of available Display Resolutions, select a display
resolution. The correct source directory must be specified. Once
the installation is complete, the system must be shut down and
restarted for changes to take effect.
Please note the following limitations regarding WIN-OS/2.
1. The WIN-OS/2 full screen session should be set to Enhanced
Capability. The default setting is Standard Mode. If this setting is
not changed, Windows will not run.
2. WIN-OS/2 should be started by selecting the WIN-OS/2 Full
Screen Icon in the Command Prompts folder, or with the WIN
command in a DOS Full Screen or OS/2 Full Screen session.
3. Do not start WIN-OS/2 in a DOS or OS/2 Window. The system
does not support the enhanced video mode being used in a
window, and therefore will not run.
72
SBC-456/456E User Manual
Advertisement
Table of Contents
