Samsung SRN-473S User Manual page 86

menu setup
• Video Output : Select a video output type from <hdmi> and <vgA>.
If your selection of <hdmi> or <vgA> does not match with the monitor setting, the video may not be output.
If you press the [ STop ( @ )]  [ Zoom ]  [ STop ( @ )]  [ Zoom ]  [ menu ] button on your remote control,
the basic resolution pop up will appear. You can adjust the desired resolution in it.
If the changed resolution is not supported by the monitor, the video may not be displayed properly. If this is the case, the screen
`
will restore the default resolution after a certain time. Then, you can change it to a different resolution.
Specify the event display time and dwell time in consideration of the video delay depending on the network environment.
`
M
To adjust the display position
Some monitors many not display information (camera name, icon, time information, etc.) about the NVR,
depending on the condition. Then, you can change the display position of the data.
FULL NO
1. From the monitor setup menu, select <display position Setup>.
2. Using the directional key or number button on the remote control, you can adjust the screen.
3. Press <oK>.
86_ menu setup