Sanyo SFX-33 Service Manual page 9

(6)-2 One touch dial memory programming
Up to 28 telephone or fax numbers (and corresponding names) can be stored in the SFX-33'S memory.
The fax/phone numbers stored to each of the 8 one-touch dialing keys (1-8) can be dialed out at the touch of a
single key. Write the names of these numbers onto the supplied one-touch key template.
An additional 20 numbers can be stored using the speed-dialing numbers (01-20).
1. Press [MENU] 3 times.
3:0. T & S.D SET?
2. Press [SET].
O.T No. =
?
3. Press one-touch dialing key (1 -8).
Example: To program a number in the one-touch
key 2, press [one-touch key 2].
4. Press [SET].
I
O.T No. =
?
5. Enter the party's name (to a maximum of 16 characters).
EDWARD~ :ABCDE
6. Press [SET].
7. Enter the fax (or telephone) number.
8,
9
(A maximum of 32 digits can be entered including
pauses and hyphens.).
Example: 1-222-3333
Press [SET].
To program other one-touch numbers, repeat
steps 3-8 above.
Press [STOP/C] to finish one-touch number programming.
l-222 -3333~
I
I
O.T No. =
?
I
Jun .26
'95 12:00 _
For instructions on printing out a numerical list of programmed named and numbers.
. To interrupt programming, press [STOP/C].
To enter a hyphen (-), press [SPEED DIAL].
To enter a three-second pause between two digits of a number, press [REDIAL/P] in the appropriate place.
A semicolon (;) indicates a pause.
If you make a mistake in entering fax/phone number, move the cursor over the digit to be changed using the
[}] key (one-touch key 7) or [ < ] key (one-touch key 6), and press [DELETE] (one-touch key 8) to delete the
digit.Then enter the correct digit.