Installation; Unpacking; Telephone Line And Ac Connections - Sanyo SFX-33 Service Manual

1. INSTALLATION
(1)
Unpacking
To unpack the SFX-33
1.
2.
3.
4.
5.
6.
7.
Open the carton.
Remove the accessories (handset, recording paper roll, etc.) from the carton.
Remove the fax machine along with the foam braces on both sides.
Remove the polyethylene wrapping around the fax machine.
Remove the transportation tapes.
Save the carton and the foam braces for later storage and/or shipping.
Place the machine where there is access to an AC outlet and a modular phone jack. (Be sure to observe the
precautions.)
Placement precautions
Avoid placing the SFX-33 in humid or dusty places, or in places where it will be exposed to excessive heat (direct
sunlight, heaters, etc.).
DO not step on or set anything on the AC cord. DAMAGE TO AC CORD IS A SAFETY RISK AND CAN CAUSE A
FIRE.
Install the unit only on a stable surface.
.Do not connect the SFX-33 to the same AC outlet as appliances that generate large amount of interference
(heaters with thermostats, appliances with motors, etc.). It is best to use a completely separate electrical outlet.
Keep the SFX-33 away from water. If water accidentally enters the unit, unplug the AC power cord immediately.
DO NOT PLUG THE UNIT IN AGAIN. Contact and authorized Sanyo service center or dealer.
Handling precaution
Avoid bending, kinking or damaging the power cord.
Never insert or remove the power cord with wet hands. Also, be sure to hold the cord by the plug when removing
it from the outlet.
.Do not remove any parts that are held in place with screws. (The SFX-33 dose not contain any user-serviceable
items.)
Maintain standard room temperature 5"C-35"C(41 OF-95°F) during use. Do not subject the unit to shock or
vibration. Do not move the unit while it is in use.
.A rapid increase in room temperature in cool weather can cause condensation to form inside the unit.
If this happens, wait at least 15 minutes after turning the unit on before attempting to operate it. Failure to do so
may result in paper jams and/or poor print quality.
When cleaning the cover or operation panel of the unit, wipe gently using a damp cloth to which a small amount
of a neutral detergent has been added. NEVER USE SOLVENTS OR CHEMICALLY TREATED CLOTHS.
(2) Telephone line and AC connections
To AC outlet
t
u?
o
(w I [=]
3 ,~
boo)
000
000
000
000
L