Machine Initial - Sanyo SFX-110 Service Manual

(5) Machine initial
1.Connect AC plug into AC outlet.
SFX-21O: 26 Jun. 12:00 00
SFX-11O:I26 Jun. '96 12:001
2. Press [MENU] while [SET] key is being pressed and
keep this condition one second.
l: INITIAL SET ?
3. Press [SET].
ALL CLEAR ?
4. Press [SET] or [MENU].
[SET] : Initialize all memories then goes to next mode
"RAM CODE SET".
S-RAM check is also carried out at the same time.
[MENU] : Initialize individual memory.
In case of pressing [MENU], follow the steps below
-
5. Press [SET] or [MENU].
[SET] : Initialize RAM CODE DATA and goes to next item
"0.T & S.D DATA".
[MENU] : Not initialize RAM CODE DATA, just goes to next
item "0.T & S.D DATA".
6. Press [SET] or [MENU].
[SET] : Initialize O.T & S.D DATA and goes to next item
"DIAL BANK DATA"
[MENU] : Not initialize O.T & S.D DATA, just goes to next
item "DIAL BANK DATA".
7. Press [SET] or [MENU].
[SET] : Initialize DIAL BANK DATA and goes to next item
"REPORT DATA".
[MENU] : Not initialize DIAL BANK DATA, just goes to next
item "REPORT DATA".
L.
8. Press [SET] or [MENU].
[SET] : Initialize REPORT DATA and goes to next item
"RAM CORD DATA".
[MENU] : Not initialize REPORT DATA, just goes to next
item "RAM CORD SET".
9. Press [STOP] to finish Machine initial setting.
2: RAM CODE SET ?
RAM CODE CLEAR ?
O.T & S.D CLEAR?
IDIAL BANK CL EAR? I
REPORT DATA CLR?
2: RAM CODE SET ?
REMARKS
In case of S-RAM Error at step 4, alarm sounds continuously and the machine
goes into "DEAD LOCK" condition + Repair is required. (check S-RAM and its VO signals)