Lower Spray Arm - GEAppliances PermaTuf GLD28**V Technical Service Manual

Tub Gasket
The dishwasher tub gasket prevents water leakage
and fi ts in a channel that lines the rim of the
dishwasher tub. The gasket on the stainless steel
tub models includes a wire rod that provides tension
to the seal.
To remove the tub gasket:
1. For the stainless steel tub models, remove the
outer door panel. (See
.)
Steel Tub Models)
2. For the stainless steel tub models, pull the wire
rod out of the gasket.
Gasket
Wire Rod
3. For PermaTuf tub models, open the dishwasher
door.
4. Remove the dishwasher tub gasket by grasping
an end and peeling it away from the channel.
Caution: When installing the tub gasket, run your
fi nger over the gasket assuring it is smooth and
even for a proper seal. On the PermaTuf tub models,
a correctly installed gasket will have both ends of
the gasket equally spaced from the bottom of the
tub. Do not stretch the gasket to make both ends
meet the bottom of the tub.
Outer Door Panel (Stainless
Channel
Tub Gasket

Lower Spray Arm

The lower spray arm may be accessed by opening
the dishwasher door and removing the bottom rack.
Remove the lower spray arm by pulling it up while
turning it counterclockwise.
Mid Spray Arm
To remove the mid spray arm (PermaTuf tub
models):
1. Remove the end cap on each roller guide by
pushing the tab towards the center of the
dishwasher.
Right Side Shown
2. Remove the 1/4-in. hex-head screw from the
spray arm.
– 26 –
Tab
(Continued next page)