Pocket Handle - GEAppliances PermaTuf GLD28**V Technical Service Manual

Pocket Handle

To remove the pocket handle:
1. Remove the control board. (See
2. Remove the 4 Phillips-head screws holding the
pocket handle to the console.
3. Remove the pocket handle through the front of
the outer door.
Towel Bar Handle
To remove the towel bar handle:
1. Remove the inner door panel on PermaTuf tub
models or the outer door panel on stainless steel
tub models. (See
Inner Door Panel (PermaTuf Tub
or
Models) Outer Door Panel (Stainless Steel Tub
Models).)
2. Remove the two 1/4-in. hex-head screws
holding the handle to the outer door (1 on each
side).
Control Board.)
Pocket
Handle
– 21 –
Vent
PermaTuf Models
The outer door vent is located on the console. When
replacing the front panel, console, or light lens, the
vent must be removed and replaced. A new vent will
come with the console and lens as a kit.
To remove the outer vent:
1. Remove the inner door panel. (See
Panel (PermaTuf Tub Models).)
2. Pry the vent louver off the outer door panel with
a fl at blade screwdriver.
Vent
Caution: To prevent water leakage, it is important to
install the new vent on a clean panel using double-
backed tape. If necessary, remove excess adhesive
on the panel before installing the new vent.
Inner Door
Adhesive
(Continued next page)