Vermont Castings VWDV70NTSCSB Installation And Operating Instructions Manual page 32

VWDV70 Series Gas Fireplace
4. Place the large rear right log #2 by aligning the three
(3) holes in the bottom of the log with the three (3) pins.
Figure 50
Large Rear Right
Log #2
Figure 50
5. Place decorative colored glass supplied with fi replace.
Page 30
6. Place medium top middle log #3 across the rear logs
by aligning the two (2) recesses on the bottom of the
log with the key protrusions on each of the rear logs.
The front branch of the top log may rest on top of the
decorative colored glass. Figure 51
Figure 51
7. Place the medium top left log #4 onto the left end of
the rear left log #1 by aligning the recess with the key
protrusion on the rear left log. Figure 52
32
Medium Top Middle
Log #3
Medium Top
Left Log #4
Figure 52
8. Place the medium top right log #5 onto the center of
the rear right log #2 by aligning the recess with the key
protrusion on the rear right log. Figure 53
Medium Top Right
Log #5
Figure 53
9. Place the small front left log #6 on top of the decorative
glass towards the left side of the hearth. Figure 54
IMPORTANT: Do not place this log in or near the burner
port area. To prevent sooting and poor combustion, do not
allow the burner fl ames to contact this log.
FINAL INSTALLATION
20306745