Operation And Important Riding Points; Starting The Engine - Yamaha YZFR3F Owner's Manual

OPERATION AND IMPORTANT RIDING POINTS

Read the Owner's Manual carefully to
become familiar with all controls. If
there is a control or function you do not
understand, ask your Yamaha dealer.
WARNING
Failure to familiarize yourself with
the controls can lead to loss of con-
trol, which could cause an accident
or injury.
6
EAU15952
TIP
This model is equipped with:
 a lean angle sensor to stop the en-
gine in case of a turnover. In this
EWA10272
case, the display will indicate error
code 30, but this is not a malfunc-
tion. Turn the key to "
to " " to clear the error code.
Failing to do so will prevent the en-
gine from starting even though the
engine will crank when pushing
the start switch.
 an engine auto-stop system. The
engine stops automatically if left
idling for 20 minutes. If the engine
stops, simply push the start
switch to restart the engine.
EAU62513

Starting the engine

In order for the ignition circuit cut-off
system to enable starting, one of the
following conditions must be met:
 The transmission is in the neutral
 The transmission is in gear with
" and then
1. Turn the key to "
2. Shift the transmission into the
3. Start the engine by pushing the
6-1
position.
the clutch lever pulled and the
sidestand up.
See page 4-20 for more informa-
tion.
" and make
sure that the engine stop switch is
set to " ".
The engine trouble warning light
should come on for a few sec-
onds, then go off. NOTICE: If the
warning light does not go off,
have a Yamaha dealer check its
electrical circuit.
[ECAT1121]
neutral position. The neutral indi-
cator light should come on. If not,
ask a Yamaha dealer to check the
electrical circuit.
start switch.
EAUN0680