Yamaha YZFR3F Owner's Manual page 26

INSTRUMENT AND CONTROL FUNCTIONS
 Brightness: this function allows
you to adjust the brightness of the
indicator light.
To adjust the shift timing indicator light
1. Turn the key to "
2. Push and hold the "SEL" button.
3. Turn the key to "
4
lease the "SEL" button after five
seconds. The shift timing indicator
light can now be adjusted.
To set the flashing pattern
1. Push the "RES" button to select
one of the following flashing pat-
tern settings:
 On: the indicator light stays
on when activated. (This set-
ting is selected when the indi-
cator light stays on.)
 Flash:
the
flashes when activated. (This
setting is selected when the
indicator light flashes four
times per second.)
 Off: the indicator light is deac-
tivated; in other words, it
does not come on or flash.
2. Push the "SEL" button to confirm
the selected flashing pattern. The
". shift timing indicator light changes
to the activation point setting
", and then re- mode.
The tachometer will show the current
setting r/min for the activation point
and deactivation point setting modes.
To set the shift activation point
TIP
The shift timing indicator light activa-
tion point can be set between 7000
r/min and 13500 r/min. From 7000
r/min to 12000 r/min, the indicator light
can be set in increments of 500 r/min.
indicator light
From 12000 r/min to 13500 r/min, the
indicator light can be set in increments
of 200 r/min.
1. Push the "RES" button to select
the desired engine speed for acti-
vating the indicator light.
(This setting is selected when
the indicator light flashes
once every two seconds.)
4-9
2. Push the "SEL" button to confirm
the selected engine speed. The
control mode changes to the de-
activation point setting mode.
To set the deactivation point
TIP
 The shift timing indicator light de-
activation point can be set be-
tween 7000 r/min and 13500
r/min. From 7000 r/min to 12000
r/min, the indicator light can be set
in increments of 500 r/min. From
12000 r/min to 13500 r/min, the in-
dicator light can be set in incre-
ments of 200 r/min.
 Be sure to set the deactivation
point to a higher engine speed
than for the activation point, other-
wise the shift timing indicator light
will not come on.
1. Push the "RES" button to select
the desired engine speed for de-
activating the indicator light.
2. Push the "SEL" button to confirm
the selected engine speed. The
control mode changes to the
brightness setting mode.