Floorboard Fitting Kit; Picture To Left - Suffolk SS100 Build Manual

SS100 Build Manual (Export Edition)
Figure 15 – Floorboard Fitting Kit
A & B 2no. M6 x 20mm countersunk slot screws – drill 5mm hole & tap M6
C1 & D1 2no. M6 x 20mm countersunk slot screws – drill 5mm hole & tap M6
C2 & D2 4no. 5/16" x 1 1/4" UNF socket head cap screws for seat runners – drill 7mm & tap
5/16"unf
C3 & D3 2no. M6 claw nuts with screws – drill 6.5mm hole and hammer in nut on top surface. Screw
angle brackets to under side of board into claw nuts
1no. M6 claw nut & screw and 2no. small wood screws for clutch fluid filler cover
F1 & F2 2no. self tapping countersunk posi drive screws – screw into metalwork
F3 & F4 2no. M5 x 20mm machine screws screws – drill 4mm holes & tap M5 into angle
F5 & F6 4no. small countersunk woodscrews for fixing hinges onto section 'G'
G1 & G2 2no. self tapping countersunk posi drive screws – screw into metalwork
G3 & G4 4no. small countersunk woodscrews for fixing hinges onto section 'H'
H 2no. 7/16" unf bolts ('+' into the captive nuts on chassis)
J1 & J2 16no. countersunk slot wood screws with cup washers for tunnels
- Fixings supplied in Nut & Bolt kit. All other fixings supplied separately with this kit.

Picture to left

This shows an example of how the rear
floorboards can be fitted with a piano hinge
format allowing great access to the rear brakes
and suspension.
These panels can also be made removable with
a hidden tool tray under the top panel that can
have a hinged lid cut in.
Page 87
Rev 10 November 2013