Strake Fitting; Cutting And Gluing Rubber Insert - Suffolk SS100 Build Manual

SS100 Build Manual (Export Edition)
Figure 13 – Strake Fitting
Positions for strakes:
Rear end of strakes level and 83 mm forward of rear edge of door.
•
First strake fitting - A 25 mm from edge of body.
•
Second strake fitting - E 25 mm from wing beading, 30 mm if fitting before beading.
•
Third strake fitting – C central between A and E.
•
Forth strake fitting – B central between A and C.
•
Fifth strake fitting – D central between C and E.
•

Cutting and gluing rubber insert:

Cut "V" into rubber before bringing together with super glue.
Page 85
Rev 10 November 2013
E
D
C
B
A