Installation Instructions - Whirlpool MH3184XPB Service Manual

ROTATE BLOWER MOTOR
The microwave oven is set for recirculation
installation. For wall or roof venting, changes
must be made to the venting system.
NOTE: Skip this section if you are using recir-
culation installation. Keep the damper assem-
bly in case the venting method is changed, or
the microwave oven is reinstalled in another
location where wall or roof venting may be
used.
Wall Venting Installation Only
1. Remove screw attaching damper plate
to top of microwave oven exterior. Slide
damper plate back and lift up.
A Screw
B. Damper plate
2. Keep damper plate and screw together
and set aside.
3. Remove two screws attaching blower
motor to back of microwave oven.
A
4. Lift blower motor out of microwave oven.
A. Blower motor

INSTALLATION INSTRUCTIONS

A
B
A. Screws
A
5. Rotate blower motor end over end.
6. Rotate blower motor so that exhaust
ports face the back of microwave oven,
and lower blower motor back into the
microwave oven.
A. Exhaust port
7. Reattach blower motor to back of
microwave oven with 2 screws removed
in Step 3.
8. Reattach damper plate. Make sure tabs
at top and back of damper plate are in-
serted fully into their respective slots in
the microwave oven.
A
A. Damper plate
B. Tabs at back of damper plate
C. Slots in back of microwave oven exterior
D. Damper plate tabs
E. Slots in top of microwave oven exterior
9. Secure damper plate with screw.
2-3
B C D E
A