Chapter 2 Hardware Overview; Additional Installation Requirements; Front Panel; Sam1008 Front Panel Leds - ZyXEL Communications IES-1000 User Manual

2.1

Additional Installation Requirements

•
A computer with Ethernet 10Base-T or 100Base-TX NIC (Network Interface Card)
•
WAN service provided by a local phone company
•
A computer with terminal emulation software configured to the following parameters:
VT100 terminal emulation
9600 bps
No parity, 8 data bits, 1 stop bit
No flow control
2.2

Front Panel

The following figure shows the front panel of the IES-1000 with two installed SAM1008 network modules.
2.2.1

SAM1008 Front Panel LEDs

The following table describes the LED indicators on the front panel of a SAM1008 network module.
LED COLOR STATUS
ALM Red
SYS Green
Hardware Overview
This chapter gives a brief introduction to the IES-1000 hardware.
Figure 2-1 Front Panel

Table 2-1 SAM1008 Network Module LED Descriptions

Blinking The sensor that detects if the module has overheated has failed.
On The module has overheated.
Off The module is functioning within normal temperature parameters.
Blinking The system is initializing.
On The module is on and functioning properly.
Off The system is not receiving power, not ready or has a malfunction.
Hardware Overview
DESCRIPTION
IES-1000 User's Guide
Chapter 2
2-1