Brinkmann Vertex Sear 810-3885-G Owner's Manual page 11

Table of Contents

Advertisement

Available languages

Available languages

Note: Observe fl ame height when lit: Flame should be a Blue/Yellow
color between 3–5 centimeters when burner is on " " (HIGH).
See section in manual on burner adjustment to adjust fl ame.
Note: Vertex Sear Burner must be "OFF" to use the two lower burners. The two burners under the
Vertex Sear Burner will not turn ON when the Vertex Sear Burner is in the "ON" position.
LIGHTING THE VERTEX SEAR BURNER:
1. Open lid before lighting Vertex Sear burner.
2. Make sure Vertex Sear burner control knob is in the "OFF" position.
3. Push and turn the Vertex Sear burner control knob to the "ON"
position.
4. Press the electronic igniter and hold for 3–5 seconds to light burner.
5. If ignition does NOT occur in 5 seconds, turn control knob to
"OFF", wait 5 minutes to allow gas to dissipate and repeat lighting
procedure.
6. If burner does not ignite using the push-button igniter, wait 5 minutes,
see "Match Lighting the Vertex Sear Burner" section.
7. To turn off, turn control knob clockwise until it locks in the "OFF"
position. This does not turn off the gas fl ow from the cylinder.
Note: If burner does not light or fl ame is too low, See "Trouble
Shooting" section of the owners manual.
MATCH LIGHTING THE VERTEX SEAR BURNER:
1. Open lid before lighting Vertex Sear burner.
2. Turn the Vertex Sear burner control knob to "OFF".
3. Strike and carefully place a match approximately 1 to 2 centimeters
from the burner.
4. Turn the Vertex Sear burner control knob to the "ON" position. The
burner should light within 5 seconds.
5. If the burner does not light, turn the control knob to "OFF" and wait
5 minutes for gas to dissipate and repeat lighting procedure.
6. If the burner does not light within the fi rst few attempts of match
lighting, there is a problem with the gas supply. Turn off the gas at
the burner and cylinder. DO NOT attempt to operate the grill until the
problem is found and corrected.
Note: If burner does not light or fl ame is too low, See "Trouble
Shooting" section of the owners manual.
5 cm
3 cm
0 cm
OFF
10

Advertisement

Chapters

Table of Contents
loading

Table of Contents