Table of Contents
Advertisement
Registration and deregistration
Adding and registering handsets
If registration fails, follow the instructions, as mentioned below, to
register a handset to the telephone base.
NOTES:
•
Make sure the handset is out of the telephone base or charger and shows
To register HS, see manual.
•
For CL83114/CL83214/CL83314/CL83364/CL83414/CL83464 telephone, when
the telephone base prompts you to set the date and time, follow the instructions
in the user's manual to set it or skip the setting by pressing CANCEL.
•
For CL83114/CL83214/CL83314/CL83364/CL83414/CL83464 telephone, after
the date and time setting is done or skipped, the telephone base will prompt if
you want to set up the answering system. Press
via voice guide or press CANCEL to skip the setup. The telephone base now
enters idle mode.
1. On the telephone base, press and hold
for about five seconds. Then, release the button after the IN USE
light turns on.
2. On the handset, press QUIET # (pound key) immediately and the
screen shows Registering... Please wait.
3. When the registration process completes, HANDSET X
Registered appears on the screen ( ( HANDSET represents the
handset name, X represents the handset number). The handset
beeps and the IN USE light turns off. The handset is now
registered with the telephone base.
The system will automatically try to register again if registration
fails. If it fails after the third try, Registration failed appears on the
screen. The handset shows To register HS, see manual. This may
take up to five minutes to occur. Please start again from Step 1.
NOTES:
•
You cannot register a handset if any other system handset is in use.
•
For CL83114/CL83214/CL83314/CL83364/CL83414/CL83464 telephone, the
telephone base shows Registration slots are full and sounds two beeps, if you
try to register more than 12 handsets.
/SELECT to start the setup
MENU
/HANDSET LOCATOR
10
Hide quick links:
Advertisement
Table of Contents
