Replacing Batteries; Technical Specifications Pro-Ject Stereo Box S Phono; Service; Warranty - Pro-Ject Audio Systems Stereo Box S Phono Instructions For Use

Replacing batteries

Proceed as follows:
 Unlock and slide open the battery case cover
 Replace the battery.
Make sure the battery is the right way round !

Close the battery case cover
Battery type: 1 x CR2032 / 3V or 1 x CR2025 / 3V
Do not dispose the batteries as ordinary domestic refuse. Please dispose your exhausted batteries at
the appropriate collection sites - usually located at supermarkets and drugstores.

Technical specifications Pro-Ject Stereo Box S Phono

Power output:
Frequency response:
Channel separation:
Noise floor:
THD:
Gain:
Line-level inputs:
Phono input:
Phono amplifier
RIAA-equalisation curve accuracy
Input impedance:
Speaker connectors:
Outboard power supply:
Power consumption:
Replacement battery remote control:
Dimensions W x H x D (D with sockets): 206 x 40 x 150 (165)mm
Weight:

Service

Should you encounter a problem which you are not able to alleviate or identify despite the above information,
please contact your dealer for further advice. Only when the problem cannot be resolved there should the
unit be sent to the responsible distributor in your country.

Warranty

The manufacturer accepts no responsibility for damage caused by not adhering to these instructions
for use. Modification or change to any part of the product by unauthorized persons release the
manufacturer from any liability over and above the lawful rights of the customer.

Copyright, trademarks

Pro-Ject Audio Systems is a Registered Trademark of
H. Lichtenegger.
This guide was produced by: Pro-Ject Audio Systems
Copyright © 2015. All rights reserved.
4
© Pro-Ject Audio Systems · Pro-Ject Stereo Box S Phono · Revision 2015.1.8
2 x 25W/37W at 8 ohms/4 ohms (both channels driven)
20Hz - 20kHz (- 1,5dB)
> 40dB at 20kHz
> -100dBA
<0,1% at 10W
31dB
3 pairs RCA/phono sockets (IN2,IN3,IN4)
1 pair RCA/phono sockets (IN1)
Moving magnet (MM)
20Hz - 20kHz / max. 0,5dB
20kohms
4mm  banana plugs, spades connectors or naked wire
20V/3A DC, suitable for your country's mains supply
3A DC, <1W in standby
1 x CR2032 / 3V or 1 x CR2025 / 3V
1120g without power supply
The information was correct at the time of going to
press. The manufacturer reserves the right to make
changes to the technical specification without prior
notice as deemed necessary to uphold the ongoing
process of technical development.