Advertisement
Replacing batteries
Proceed as follows:
Unlock and slide open the battery case cover
Replace the battery.
Make sure the battery is the right way round !
Close the battery case cover
Battery type: 1 x CR2032 / 3V or 1 x CR2025 / 3V
Do not dispose the batteries as ordinary domestic refuse. Please dispose your exhausted batteries at
the appropriate collection sites - usually located at supermarkets and drugstores.
Technical specifications Pro-Ject Stereo Box RS
Tubes:
Power output:
Frequency response:
Noise floor:
THD:
Gain:
Pre out (Out Variable):
Subwoofer out (Sub):
Record out (Out Fix):
Line-level inputs:
Input impedance:
Wiring XLR sockets:
Speaker connectors:
Outboard power supply:
Power consumption:
Replacement battery remote control:
Dimensions W x H x D (D with sockets): 206 x 72 x 200 (210)mm
Weight:
Service
Should you encounter a problem which you are not able to alleviate or identify, please contact your dealer for
further advice. Only when the problem cannot be resolved there should the unit be sent to the responsible
distributor in your country.
Warranty
The manufacturer accepts no responsibility for damage caused by not adhering to these instructions
for use. Modification or change to any part of the product by unauthorized persons release the
manufacturer from any liability over and above the lawful rights of the customer.
Copyright
PRO-JECT is a Registered Trademark of H. Lichtenegger.
This guide was produced by: Audio Trade GmbH
Copyright
©
2014. All rights reserved.
4
© Audio Trade GmbH · Pro-Ject Stereo Box RS · Revision 2014.2.1
2 x ECC88 (6922)
2 x 80W/120W at 8 ohms/4 ohms (both channels driven)
20Hz - 50kHz (-1,5dB/-3dB)
90dB (A weighted)
0,1% (100W)
31dB
RCA/phono sockets, gain 12db
RCA/phono socket, gain 18dB
RCA/phono sockets, gain 0dB (Fixed output signal)
4 pair RCA/phono sockets and 1 pair XLR sockets
50kohms for RCA input In 1 - In 5 and 20kohms XLR input In 6
1 ground, 2 "hot" and 3 "cold"
4mm banana plugs, spades connectors or naked wire
±48V/2,5A DC, suitable for your country's mains supply
2,5A DC, <1W in standby
1 x CR2032 / 3V or 1 x CR2025 / 3V
2650g without power supply
The information was correct at the time of going to
press. The manufacturer reserves the right to make
changes to the technical specification without prior
notice as deemed necessary to uphold the ongoing
process of technical development.
Advertisement
