Polar Electro Loop 2 User Manual page 13

Wrap it around your wrist and take note of the numbers you get. There's one number for both ends of
the bracelet. Each number represents the number of blocks between the grooves inside your bracelet
you need to take off.
The bracelet is more comfortable to wear when it is a bit loose.
4. Trim the bracelet carefully from both ends.
To make sure the display will be in the center, it's important that you shorten the bracelet from both
ends.
Count as many blocks from one end as the number you measured. Follow the straight line in the groove
and between the spring bar holes and then carefully cut the bracelet.
Be careful not to cut into the spring bar holes.
Repeat the action to the other side of the bracelet.
13