Furuno TZTL12F Installation Manual page 31

Output PGN
The CAN bus output PGN setting (found under the [Initial Setup] menu) is global to the
network. Note that only one NavNet TZtouch2 will output CAN bus data on the
network at a time: the NavNet TZtouch2 which is powered ON first. If that display is
turned OFF, another will take its place to output the data.
PGN Description
059392 ISO Acknowledgment
059904 ISO Request
060928 ISO Address Claim
NMEA-Request group
function
NMEA-Command group
126208
function
NMEA-Acknowledge
group function
PGN List-Transmit
PGN's group function
126464
PGN List-Received
PGN's group function
126992 System Time
126993 Heartbeat
126996 Product Information
127250 Vessel Heading
127251 Rate of Turn
127257 Attitude
127258 Magnetic Variation
128259 Speed
128267 Water Depth
129025 Position, Rapid Update
129026 COG & SOG, Rapid
Update
129029 GNSS Position Data
129033 Local Time Offset
129283 Cross Track Error
129284 Navigation Data
129285 Navigation-Route/WP
Information
130306 Wind Data
130310 Environmental
Parameters
130312 Temperature
130313 Humidity
130314 Actual Pressure
130316 Temp., Extended Range
Remarks
For Certification Level A/B, Refusing output requirement
For Certification Level A/B, Requiring output
For Certification Level A/B
• Address autonomy
• Receiving output requirement
For Certification Level A/+
• Address autonomy
• Receiving output requirement
For Certification Level A/+
Changing the setting of other equipment
For Certification Level A/+
Sending the confirmation for NMEA-Request group function
and NMEA-Command group function
For Certification Level A/+
Receiving output requirement
For Certification Level A/+
Receiving output requirement
For Certification Level A/B
Receiving output requirement
• Outputs when waypoint is set/changed (own ship's
position is required)
• Outputs when receiving ISO request
Outputs when receiving the ISO request
2. WIRING
Output cycle (msec)
1000
100
100
1000
1000
1000
1000
100
250
1000
1000
1000
1000
100
500
2000
2000
2000
2-9