Desktop Mounting (Option) - Furuno TZTL12F Installation Manual

1. MOUNTING
4. Set the unit and F Mount Panel into the cutout as shown in the figure to the right,
then use the supplied self-tapping screws (SUS304  4 pcs.), fix the F Mount
Panel to the console.
Note: Where the mounting location may be exposed to water (spray or splash),
apply a bead of marine sealant around the rear of the F Mount Panel, for
waterproofing, before setting the F Mount Panel and unit into the cutout. Wipe the
area clean to remove any marine sealant residue and allow time for the marine
sealant to dry.
1.4

Desktop Mounting (option)

Follow the appropriate procedure below to mount the TZTL12F or TZTL15F.
1.4.1 How to mount the TZTL12F
Use the optional kit Bracket12 (contents shown below), for mounting the TZTL12F.
Type
OP19-13
1. Fix the hanger by using self-tapping screws (520
SUS304, supplied). The screw locations are indicated in
the figure to the right.
2. Place the TZTL12F face-down on a soft, clean
surface, then screw the knob bolts into the
TZTL12F, leaving a gap of approximately 30
mm.
3. Set the TZTL12F unit to the hanger and tighten
the knob bolts.
Note: When setting the TZTL12F into the
hanger, the concave section of the unit and the
convex section of the hanger must be aligned.
1-4
Code
Knob bolt  2 (Code No.: 100-365-900-10), Self-tapping
001-337-410
screws (SUS304 520)  4 (Code No.: 000-162-608-10),
Hanger  1 (Code No.: 100-397-080-10).
Contents
Approx. 30 mm gap
Knob bolts
Unit concave Hanger convex
Hanger