B&B Electronics SPECTRE Configuration Manual page 61

B&B Electronics, Inc.
Note: If no phone number is filled in, the router will accept incoming messages from all phone
numbers. If any phone numbers are entered into the list, the router will only accept SMS
messages which originate from those numbers.
Control SMS messages cannot change the router configuration. Any changes made to
the router by an SMS message will only remain in effect until the router is restarted. After a
reboot, the router configuration will return to the settings in non-volatile memory. For example, if
the router is switched offline by an SMS message, the router will remain offline until the next
time it is power cycled or re-booted.
To control the router using SMS, the message text must contain the control command.
Table 48 lists the SMS control messages that are supported.
SMS Control Message
go online sim 1
go online sim 2
go online
go offline
set out0=0
set out0=1
set out1=0
set out1=1
set profile std
set profile alt1
set profile alt2
set profile alt3
reboot
get ip
You may send and receive SMS messages using either the serial expansion ports or a
TCP connection over the Ethernet network. For serial communication, the baud rate must be set
to match the attached host. Select option Enable AT-SMS protocol on expansion port 1 to
allow messages to be sent and received using serial port 1.
Item Description
Baud rate Communication speed expansion port 1
Select option Enable AT-SMS protocol on expansion port 2 to allow messages to be
sent and received using serial port 2.
Item Description
Baud rate Communication speed expansion port 2
It is also possible to send and receive SMS messages over a TCP/IP connection by
choosing Enable AT-SMS protocol on TCP port. The TCP port used for sending and receiving
SMS messages must be entered into the configuration field.
Switch to SIM1 card
Switch to SIM2 card
Switch router in online mode
PPP connection termination
Set binary I/O output to 0
Set binary I/O output to 1
Set binary output on port 1 to a 0
Set binary output on port 1 to a 1
Set standard profile
Set alternative profile 1
Set alternative profile 2
Set alternative profile 3
Router reboot
Router will send an SMS message back with the IP address from
the SIM card.
Table 47: SMS Control Commands
Table 48: Send SMS on serial PORT1 configuration
Table 49: Send SMS on serial PORT2 configuration
Description
61
SPECTRE Configuration Manual
710-10001-02 Rev. 3.0
www.bb-elec.com
www.bb-europe.com