Reverse - FUTABA 8J Instruction Manual

MDL-TRANS
[ T8J of the transmits side ]
1. The data of a model to send is called by MDL-SEL.
2. MODE of MDL-TRANS is set to TRANSFER .
3. Execute .
Servo reversing ( REVERSE ): changes the direction an individual servo responds to a CONTROL STICK motion.
)RU &&30 KHOLFRSWHUV EH VXUH WR UHDG WKH VHFWLRQ RQ SWASH AFR (p. 75) before reversing any servos.
With the exception of CCPM helicopters, always complete your servo reversing prior to any other programming.
When using ACRO functions that control multiple servos, such as FLAPERON or V-TAIL , it may be confusing to determine
NOTE: THR-REV is a special function that reverses the entire throttle control, including moving the trim functionality to
WKH 6WLFN¶V XSSHU KDOI 7R XVH THR-REV : see p.92. This change affects all models in the radio.
GOAL of EXAMPLE:
Reverse the direction of the elevator
servo.
Where next?
whether the servo needs to be reversed or a setting in the function needs to
be reversed. Refer to the instructions for each specialized function for further
details.
Always check servo direction prior to every flight as an additional
SUHFDXWLRQ WR FRQ¿UP SURSHU PRGHO PHPRU\ KRRN XSV DQG UDGLR IXQFWLRQ
STEPS:
Open REVERSE function.
C h o o s e p r o p e r c h a n n e l a n d s e t
direction. (Ex: ELE REV )
&RQ¿UP \RXU FKDQJH
Close.
Adjust servo travel with END POINT : see p. 36.
Set up dual/triple rates and exponential( D/R , EXP ): see p. 39.
6HW XS ÀLJKW WLPHUV VHH S 
Set up trainer functions: see p. 44.
[ T8J of the receives side ]
*It receives for 10 seconds.
1. The clear model is called by MDL-SEL.
2. MODE of MDL-TRANS is set to RECEIVE .
3. Execute .
INPUTS:
for 1 second.
to REVERSE .
to ELE .
for 1 second.
Sure? displays.
35