Transmitter Batteries - FUTABA 8J Instruction Manual

INSTALLATION AND REMOVAL OF THE TRANSMITTER BATTERY
WARNING
Be careful not to drop the battery.
Never disconnect the battery connector
from the T8J transmitter after turning off
the power until the screen is completely
blank and the transmitter has shut down
completely.
* Internal devices such as memories may be damaged.
* If there is any problem, the message "Backup Error" will
be shown the next time when you turn on the power of
the transmitter. Do not use the transmitter as it is. Send it
to the Futaba Service Center.
WARNING
Do not connect any other chargers except
the special charger to this charging
connector.
*If you take out the Ni-MH battery HT5F1700B from the
transmitter, you can use the optional quick charger CR-
2000 corresponding to Ni-MH battery.
The T8J transmitter is designed to work with either
four (4) AA alkaline dry cell batteries, or HT5F1700B/
FT2F2100B battery pack, both available separately.
The transmitter batteries used are a matter of personal
preference. AA Alkaline batteries are available at any
local hobby shop, grocery store, etc. A battery pack
will need to be purchased from a hobby shop.
Trainer function
connector
Remove the battery BOX if you choose to use the
optional HT5F1700B/FT2F2100B battery pack,
which can be recharged from the transmitter.
push and slide down
And "BATT TYPE" in a PARAMETER is
changed into "5CELL" in the procedure of P.33.
Battery cover
NOTE: If you need to remove or replace the
transmitter battery, do not pull strongly on the
battery wires to remove it. Insert the connector
straight as shown.
N O T E : T h i s plug is for charging HT5F1700B.
The other battery cannot be charged.
FT2F2100B is removed from a transmitter, and
charges with an exclusive charger(LBC-4E5).
12