Adjusting The Length Of The Control Sticks - FUTABA 8J Instruction Manual

ADJUSTING THE IENGTH OF THE CONTROL STICKS
Stick tip A Locking piece B
Stick lever tension adjustment
<RX PD\ DGMXVW WKH WHQVLRQ RI \RXU VWLFNV WR SURYLGH WKH IHHO WKDW \RX SUHIHU IRU IO\LQJ 7R DGMXVW \RXU
springs, you'll have to remove the rear case of the transmitter. First, remove the battery cover on the rear
of the transmitter. Next, unplug the battery wire, and remove the battery from the transmitter. Next, using a
screwdriver, remove the four screws that hold the transmitter's rear cover in position, and put them in a safe
SODFH *HQWO\ HDVH RII WKH WUDQVPLWWHU¶V UHDU FRYHU 1RZ \RX¶OO VHH WKH YLHZ VKRZQ LQ WKH ¿JXUH DERYH
Using a small Phillips screwdriver, rotate the adjusting screw for each stick for the desired spring tension.
The tension increases when the adjusting screw is turned clockwise. When you are satisfied with the
spring tensions, reattach the transmitter's rear cover. When the cover is properly in place, reinstall and tighten
the four screws. Reinstall the battery and cover.
screw is clockwise.
tick tension ma im m
ADJUSTING DISPLAY CONTRAST
To adjust the display contrast, from the home menu press and hold the END BUTTON.
Push the ＋− KEY while still holding the END BUTTON:
＋ KEY to brighten
− KEY to darken the display
<RX PD\ FKDQJH WKH OHQJWK RI WKH FRQWURO VWLFNV WR PDNH \RXU
transmitter more comfortable to hold and operate. To lengthen or
VKRUWHQ \RXU WUDQVPLWWHU¶V VWLFNV ¿UVW XQORFN WKH VWLFN WLS E\ KROGLQJ
locking piece B and turning stick tip A counterclockwise. Next, move
the locking piece B up or down (to lengthen or shorten). When the
length feels comfortable, lock the position by turning locking piece B
counterclockwise.
Four screws are
removed and rear
case is removed.
screw is co nter clockwise.
tick tension minim m
Aileron
Elevator
Stick
Mode 2 transmitter with rear case removed.
※A screw touches a case.
16
Rudder
Stick
screw is kept
rom coming o t
rom a line.