4. Connect the nipple of the mixing chamber onto the silicone tube
5. Hold the mixing chamber sideways when sliding the nipple onto the sili-
cone tube
6. Slide the Mixing chamber in position and push firmly into the pump deck.
!
CAUTION:
Make sure that the lid of the mixing chamber is properly installed and screwed on
tight.
Failure doing so will cause the entire chamber to flood with drinks and
eliminating the anti-splattering effect.
7. Replace the Nozzle and Static Mixer, and close the cabinet door
Priming:
Place a small cup onto the drip tray and press the cancel/Pour button for 2 seconds
to prime the mixing system
If only water leaves the nozzle, check if the RUN/FLUSH switch onto the pump
platform is placed in the RUN position
© 2013-2015, Cornelius Inc.
- 12 -
Quest Elite QLT 2000
Figure 24.
Figure 25.
Figure 26.
Publication Number: 620058442